REPAIR HEATER KIT FOR FAULTY WIDE GHD MAX VERSION S7N421 HAIR STRAIGHTENERS by GHD®

Code 375451082201
£0.00
£39.99
Code 375451082201
£0.00
£39.99
Save
Earn 0 reward points with this product.

Sorry we're out of stock!

Enter your email address below and we’ll notify you as soon as it becomes available.

  • Description
    SIRIUSHAIR® MANUFACTURED REPLACEMENT COMPONENTS FOR GHD GOLD MAX VERSION S7N421 HAIR STRAIGHTENERS. 

    • Please ensure you are suitably qualified and equipped to carry out electrical repairs, this is a complex repair kit. 
    • A multimeter and soldering iron are required.
    • This is a set of components which often fail on this model of GHD and are included in this package to enable a repair to your faulty GHD, not all components will be required.
    • These parts are for the Gold S7N261 hair straightener, the model variant is located on the label on the inside of the non switch arm of the GHD, for other model parts please look at our other listings.
    The colour of the GHD, the original component colour, or manufacturer of the part has no relevance to the operation of the parts included in the kit listed below.
    • 0.5g sachet of Halnziye® Thermal Paste (Enough for 2 ceramic heater elements).
    • 2 x new SIRIUSHAIR® replacement ceramic heaters with built in thermistors and attached thermal fuse.
    • 1 x main motherboard capacitor.
    • 1 x Q4 mosfet.
    Repair Order:

    Do not apply power.
    • Check both heater elements with a multimeter for continuity across all four wires, both inner wires are the heater/thermistor and both outer wires are the attached thermal fuse.
    • Even if you have continuity pull gently on all four wires as a short will show by a detached wire, replace with a heater from the kit.
    • If you check the metal pads on the ceramic heaters to ensure no electrical burn which if present will cause a thermal fuse failure, remove with a diamond file or replace with a heater from the kit.
    • If you have a cracked heater then you MUST replace the Q4 mosfet with the one in the kit, if the heater is not cracked then do not replace.
    • Replace the capacitor with the one in the kit even if tested ok as its ESR is difficult to test without specialist equipment.
    • Ensure wires from heaters are all pressed firmly into the PCB connectors.
    • If after powering on you get the red light then check wires from heaters are connected to the PCB correctly.
    If after using all the components the GHD still does not operate, the other known fault will be the motherboard or a faulty power cable.

    • In the interest of recycling and to promote repairing we will include a Freepost return label, if you can not repair using the kit we have supplied, simply put the GHD Hair Straightener and everything we sent in a bubble bag and write your ebay name on the label (No need to reassemble). Once received we will recycle the hair straightener and refund entirely to save going to landfill, helping the environment and promoting re-use. (ONLY AVAILABLE TO UK CUSTOMERS)

    • TUV / CE Certified UK RoHS compliant.
    • PLEASE ensure after carrying out any repair to a GHD you leave for 30 minutes before use to ensure the temperature has settled and the safety cut out feature activates correctly.

    The motherboard in the image is NOT included it is simply to show the location of the capacitors included in the repair kit supplied.